DEMO - Signal Ridge Workshop
Fictional 12,000 sf fabrication workshop with 480 V machinery, overhead lighting and a 208/120 V support area. Demonstration data only; no real client, person or address is represented.
Fault current calculated 2026-11-22. Select a panel to open it.
Notes
- T-1: The feeder on DP-W1 13,15,17 45A/3P has no raceway entered. [riser-input-missing]
- Unreviewed data: 6 NEC 2020 Chapter 9, Table 9 values used on the runs to DP-W1, LP-W1 and T-1 not yet checked against the book: AC Resistance Uncoated Copper Steel Conduit: 4/0 AWG, 3 AWG, 8 AWG; XL Steel Conduit: 4/0 AWG, 3 AWG, 8 AWG. get_voltage_drop lists the values each drop uses, and analyze_panel those that set a feeder's size. [VOLTAGE_DROP_IMPEDANCE_UNREVIEWED]
- Unreviewed data: 3 C values from Eaton's Short-Circuit Current Calculations (2014), Table 4, three single conductors at 600 V, used on the runs to DP-W1, LP-W1 and T-1, not yet checked against the bulletin: copper in steel conduit: 4/0 AWG, 3 AWG, 8 AWG. get_fault_current lists each value and where it is used. [C_VALUE_UNREVIEWED]
- Unreviewed data: 7 NEC 2020 Article 220 table values in the loads of LP-W1 not yet checked against NFPA 70 (2020): Table 220.12, Office; Table 220.42, All others, total factor; 220.14(I), single or multiple receptacle on one yoke; Table 220.44, first band limit; Table 220.44, first band factor; Table 220.44, remainder factor; 220.14(K), office receptacle minimum. get_loads lists each value and the loads that use it. [LOAD_TABLE_VALUE_UNREVIEWED]