Forewit
Shared public demo. Use fictional data. Anyone can change these projects.Join the waitlistContact

DEMO - Juniper Dental Studio

DEMO-26002Dental office202 Juniper Court, Example City - fictional siteBid and permitCommercial energy code

Fictional 3,200 sf tenant improvement with four operatories, sterilization, imaging and dedicated dental air and vacuum equipment. Demonstration data only; no real client, person or address is represented.

Panels

PanelSystemMainSpacesUpdatedActions
LP-D11 warning120/208 V, 3-phase, 4-wire225 A MCB14/42Sep 29, 2026
MP-D11 warning120/208 V, 3-phase, 4-wire125 A MCB20/30Sep 29, 2026

Fault current calculated 2026-11-22. Select a panel to open it.

Title block, DEMO - Juniper Dental Studio, DEMO-26002, ELECTRICAL RISER DIAGRAM, FAULT CURRENT CALCULATED 2026-11-22 / fnv1a32:12fde621Utility source U-2, UTILITY, 120/208V 3PH 4WDisconnect SD-1, SERVICE, DISCONNECT, 400 A 3P / 225 A FUSES, 200 KA AIC / 22.3 KA AFCPanel LP-D1, ELECTRICAL CLOSET, 120/208V 3PH 4W, 225 A MCB / 22 KA AIC / 12.2 KA AFC, feeder SD-1, P 3×#4/0, C STEEL / 70 FT, VD 1.06% / 1.06% TOT FROM SD-1Disconnect SD-2, SERVICE, DISCONNECT, 200 A 3P / 125 A FUSES, 200 KA AIC / 22.3 KA AFCPanel MP-D1, EQUIPMENT ROOM, 120/208V 3PH 4W, 125 A MCB / 22 KA AIC / 9.5 KA AFC, feeder SD-2, P 3×#1, C STEEL / 55 FT, VD 0.97% / 0.97% TOT FROM SD-2

Notes

  1. Unreviewed data: 4 NEC 2020 Chapter 9, Table 9 values used on the runs to LP-D1 and MP-D1 not yet checked against the book: AC Resistance Uncoated Copper Steel Conduit: 4/0 AWG, 1 AWG; XL Steel Conduit: 4/0 AWG, 1 AWG. get_voltage_drop lists the values each drop uses, and analyze_panel those that set a feeder's size. [VOLTAGE_DROP_IMPEDANCE_UNREVIEWED]
  2. Unreviewed data: 2 C values from Eaton's Short-Circuit Current Calculations (2014), Table 4, three single conductors at 600 V, used on the runs to LP-D1 and MP-D1, not yet checked against the bulletin: copper in steel conduit: 4/0 AWG, 1 AWG. get_fault_current lists each value and where it is used. [C_VALUE_UNREVIEWED]

Edit project

New panel

Delete ?

This can't be undone.