Forewit
Shared public demo. Use fictional data. Anyone can change these projects.Join the waitlistContact
H-GAR (DETACHED GARAGE)
H-GAR
MAIN:M.L.O.RATING:100 ASPACES:24SERVICE: 120/240 V, 1-PHASE, 3-WIREMOUNTING: SURFACEFEEDS FROM: H-1 / CIRCUITS 25,27 / 70 A FEEDERPANEL SCCR: 10 KATRIM: HINGED DOOR, NEMA 1A.I.C.: 10 KAFAULT CURRENT CALCULATED 2026-11-22 / fnv1a32:ea82f216AFC: 3.2 KA, uses Eaton Table 4 C values not yet checked against the bookA.I.C. PASS, SCCR PASS
Panel schedule for H-GAR, odd circuits on the left and even circuits on the right
CKTDESCRIPTIONKVACIRCUIT BREAKERBRANCH CIRCUITCVD%PHCKTDESCRIPTIONKVACIRCUIT BREAKERBRANCH CIRCUITCVD%PH
POLETRIPPNGNDPOLETRIPPNGND
10.42115141414--1.86A20.3115141414--2.48A
31.2120121212--1.87B41.2120121212--2.40B
50.54115141414--1.55A61.8120121212--1.07A
75.7623010--10--0.72B82.422012--12--0.67B
910----A1012----A
11----------------B12----------------B
13--120----------A14--120----------A
15----------------B16----------------B
17----------------A18----------------A
19----------------B20----------------B
21----------------A22----------------A
23----------------B24----------------B
CONNECTED LOAD: 13.62 KVAPHASE A: 59.5 APHASE B: 54.0 AIMBALANCE: 9.7%
WORST COMBINED VOLTAGE DROP: 4.13% AT CKT 2, ADVISORY, uses Table 9 values not yet checked against the book
CALCULATED LOAD: REQ, 8 LOADS TO CLASSIFY
REQ: loads without a load category are not calculated.
NOTES: Synthetic demonstration schedule. Connected loads, run lengths, raceways, installed conductor sizes, load categories, served areas, equipment ratings, energy code scope and fault-current inputs are fictional. Table values are not yet checked against the book.
Unreviewed data: 2 C values from Eaton's Short-Circuit Current Calculations (2014), Table 4, three single conductors at 600 V, used on the runs to H-1 and H-GAR, not yet checked against the bulletin: copper in PVC conduit: 2/0 AWG, 4 AWG. get_fault_current lists each value and where it is used.

Calculated load

Needs input

REQ

8 loads to classify. Open a circuit and choose each load's Category in its Loads section.

Loads without a load category are not calculated. Dwelling-unit calculations are not available yet.

Discard changes?

The panel reverts to its last save.

Discard circuit edits?

Unapplied changes to this circuit will be lost.

Leave without saving?

Unsaved changes will be lost.